Selexx Mate boot disk
3/9/15
Hi Everyone,
Does anyone have or know someone who has a Selexx Mate 2003 4x8 with the Siemens 810D controller on it? I purchased this machine for a great deal but the install disk need to be put back into the control and the Factory (Omnitech) and the Siemens folks are trying to help but so far no luck. It seems that this control was only put on around 50 machines and the documentation is only over in China where they were built. So far after 3 requests and 5 weeks there is no sign of getting this from them. It basically has the ladder logic and parameters on it and the machine is useless without those. If there is someone who has the same machine and they could make a copy and send it to me I will make it worth there time.
Thanks in advance for your help, Rob
3/11/15 #2: Selexx Mate boot disk ...
I looked at selexx with Siemens but was told to avoid it by insiders. Try contacting Siemens.
3/11/15 #3: Selexx Mate boot disk ...
Hi Alex,
They can only help with the controller, the machine builder has the parameters for the machine. I did get some help from Art and at ASI machine tool and I think they are going to start servicing these controls. The Siemens guys spent some time with me and were very helpful but they are limited with the parameters from the builder.
3/13/15 #4: Selexx Mate boot disk ...
Call Ross Goble @ Diversified Equip And Supply in North Carolina - he might have a lead
3/14/15 #5: Selexx Mate boot disk ...
Call Jack @ Limtech- he might be another good source
12/19/18 #6: Selexx Mate boot disk ...
Were you able to find the disk?