|Home » Forums » Laminating and Solid Surfacing » Message||Login|
You are not logged in. Consider these WOODWEB Member advantages:
Corner rounding 3mm PVC8/15
Does any one have any insight on corner rounding. I want to use 1/8" round over bit but bearing seems to large as it would be better to have bit cut into ajacent banding by a hair. Current bit does not cut deep enough and leaves a edge. I bid on Tangent corner rounding unit and did not get it. Does any know what they use for tooling. I have done this several times in last 10 years and have never came up wiyh perfect solution other than buy a new edgebander
there is no bearing on the bottom of the bit for a machne like this. it can be adjusted any way you like. as for doing it by hand, it's gonna requite a bit of clean up after routing.
I've done quite a bit of this by hand as banders I have used in the past where never dialed in as well as they shoulda been.
Take a look at Betterley's PVC trim router or there file-rite trimmer.