|Home » Forums » Sawing and Drying Forum » Message||Login|
You are not logged in. Consider these WOODWEB Member advantages:
Drying Black Spruce dead straight7/11
I am getting into arrowshaft production for the archery industry. I plan to saw, air-dry, then kiln-dry it down to about 7%. Could someone with experience with spruce or similar woods give my any guidelines ? I am in Manitoba, Canada. We have alot of the nice slow growth straight and limb-free trees out here. I plan to try other woods as well, like birch, tamarack, and possibly black poplar. Thanks ahead.
The first step and the key for any species is to split the wood in both directions-radial and tangential. A split follows the grain, so then saw the blanks without any slope of grain or grain angle, By sawing parallel to the split surfaces. Unless there are nearby knots, these straight grain pieces will be straight, using normal drying practices.
In following what others in the arrowshaft business do, I am cutting into 3' sections, then splitting in half. At that point, I find it difficult to try and bandsaw following those split lines. Plus some of them are spiral grain, causing yet more hardship. I find that if I saw everything once split, the grain is perfectly parallel. Does this leave me open to some cross grain still ? Thanks
There is always cross grain around a knotty area...it is in the tree.
So I understand that I am to orient the bolt (log section) so that the saw blade is right parallel with the split edge, then all my wood is as straight as an arrow? Growth rings then are quarter and rift sawn, right? Thanks ahead Gene.
There are two grain directions, so you need to align with both, so that the face and the edges are both parallel to the split faces. So you need to split the log twice, with the splits at 90 degrees about.
Gene, if you would, could you post a drawing or similar way of seeing just what you mean ? Sorry, I must have relatives from Missouri. Could you show me? Thanks
Consider a pie that you cut into four equal pieces. That is what you do with the end of a log.
Honestly, I got that quickly but I really don't know what you mean by another grain direction to consider when sawing into smaller boards after quartering. Please elaborate your meaning. Thanks again.
With a pie wedge that is 1/4 of a pie, the two cut faces are 90 degrees to each other and represent two different grain angles. You need to follow both grain angles...one follows the one split grain face with one face of the blank and the other grain angle with the other 90 degree face of the blank
Stated another way, you can saw one piece of lumber so it's face is aligned with the split face. Then before you rip this lumber into small blanks, you must split the lumber so you know what direction to rip the lumber. Oftentimes this rip direction will be parallel to the bark and not the pith.
I believe that this time, I've got it! Your latest post was what really made it clear to me. I will do that, thankyou.