Hoffmann PP2-HF - Double Dovetail Router - Serial # 7.235-3
Listing #524960 Listed on: 05/21
|Listing Type:||Machine for Sale|
|Location:||Santa Ana, CA|
Both standard brush-style router motors have been replaced with production-duty High-Frequency Router Motors for extended service life, reduced maintenance and higher production levels.
Production-duty, freestanding two-head dovetail routing machine with solid cast aluminum table and heavy steel frame. Machine is designed to rout a single dovetail keyway into two work-pieces with each machining cycle. For Dovetail Keys sizes W-0,W-1, W-2, W-3, and W-4.
Large work surface is designed to be at a comfortable working height, the router motors are controlled by a contactor and a 4” dust collection port is located at the back for connection to a central dust collection system.
The keyway locations are adjusted by positioning the guided center fence plate on the machine table; the keyway lengths (routing heights) are adjusted by setting a height-stop rod to the desired setting.
Pressing the pneumatic foot pedal starts the machining cycle:
> Pneumatic clamps secure both work-pieces and motors are switched on
> Router heads advance until pre-set height is reached
> Router heads return to home position and motors are switched off
> Pneumatic clamps release work-pieces
Output is approx. 16 routing strokes per minute, which translates into 4 completely processed rectangular frames. These numbers include material handling, but obviously depend on routing depth, feed speed, material flow and operator performance as well. Flow control valves on the main pneumatic cylinder allow the operator to adjust the upward and downward feed rate independently, depending on the material being processed. A 4" diameter dust collection port in the back is used to connect a central dust collection system.
The supplied router bits are solid tungsten carbide, made to exacting specifications. Depending on the routing depth and the material to be routed, the useable cutter life is approx. 10,000 strokes, often times even more. Every machine is shipped with a tool kit and set-up jig, which allows a router bit change in only minutes.
Hoffmann Dovetail Routing Machine PP2-HF, freestanding floor model, with two High-Frequency Router Motors and matching inverter installed, ready for operation, with lockable Emergency-Stop, with air regulator-lubricator assembly, standard 45 degree center fence plate and square stop, toolkit and manual.
Power Supply 230 volts – 3 phase
Air Supply 90 psi - approx. 0.1 cubic foot/cycle
Motors 2 x 750 Watt HF motor with double front bearing
Motor speed 18,000 rpm at idle
Collet size 1/4”
Motor carriage guides 16mm diameter guide rods, precision ground
Operation pneumatic – dual cylinder design
Max. routing height 4” – 101mm
Max. material height 5 3/4” – 146mm
Available router bits W-0, W-1, W-2, W-3 and W-4
Dimensions W/D/H 39 3/8” x 29 1/2” x 59”
Contact this Seller (Chris Noterman):
(* denotes required fields)