edgebanding issues
4/22/15
Ok I had our Brandt KDN-210 serviced by a stiles rep. We had many issues with edgebanding tracking off of the panel edges. He made a minor tilt adjustment on the glue roller and some minor pressure adjustments on the rollers. We still had some of these issues come up. So we flipped the roll of edgebanding over and it ran great. The only problem is that all of our edgebanding is manufactured with a fleece backing. I can't find anyone who makes edgebanding rolls without the fleece backing. All of our rolls are stored flat in a climate controlled shop. What can I do to make the fleece backed material run properly or are there companies out there that supply edgebanding without the fleece backing? Thanks
4/22/15 #2: edgebanding issues ...
Edgemate does, probably not the only one.
4/23/15 #3: edgebanding issues ...
The unbacked is a bit thicker, which is nice, but its not reversable. You need the rough sanded back for good adhesion.
I had tracking issues once and all I remember is that it had to do with the alignment/heights of the tape guides and roll table.