|Home » Forums » Cabinetmaking » Message||Login|
You are not logged in. Consider these WOODWEB Member advantages:
Troubleshooting SCM Edgebander4/7
Sounds like you need a heat station rebuild. You might check underneath in control panel to see if any breakers are tripped.
Check for a tripped out breaker as Dan suggested. The problem could also be the temperature controller and contacts not closing on it to call for heat. I believe they used Gefran on that model. The problem could also be the contactor that passes the voltage to the heating elements. The heating elements could also be bad but I would doubt all of them are bad so I would suspect it would simply heat up slow if it were a heating element issue.
Have scm edgebander that when using white melamine tape put small teeth like pressure marks in tape after running thru. Any ideas why?