autofeed
9/6/15
Looking for a site in Canada preferably to buy an autofeed motor to use on my homemade bandsaw mill,any suggestions?Thanks
9/8/15 #3: autofeed ...
To control the speed I used this
Link
9/9/15 #5: autofeed ...
Hey Rod I pm'd you.Can you get bk to me asap so I can order please.
9/10/15 #6: autofeed ...
I didn't see any pm,but I don't have the stuff.You can buy the stuff from the links I gave you.
9/10/15 #7: autofeed ...
Lol, I know you don't have the stuff, I was just asking if you encountered any problems? Do you think it will be ok to use just one power feed motor or better with two? Any particular king of toggle/ rocker switch to use ? Did you order chain and sprockets from same place? Can you use smaller chain or #40 better. Sorry for all the questions but trying to get it right the first time.
9/10/15 #8: autofeed ...
You could do like I did,try one power feed and see how you like it. Nope,had no problems with any of the oreders. The chain sprokets I got here. These I used on each side of the drive sproket.
Link
9/10/15 #9: autofeed ...
This is the chain I used and were I got it
Link
9/10/15 #10: autofeed ...
This is the switch I used
Link