|Home » Forums » Solid Wood Machining Forum » Message||Login|
You are not logged in. Consider these WOODWEB Member advantages:
General 25 " Dual Drum Sander11/6
As a follow up is there a way to re wire this by putting a separate variable speed control that would go to the conveyor and a simple direct switch that would just turn the drums on?
More information is needed in order to help. Model number, motor phase, HP, magnetic or manual starter, photos of motor and switch box, photo of inside of switch box, electrical diagram if there is one etc.
Hi, THanks for your help, the model is 15250-m1 25" dual drum 3hp sander. It is a manual switch. The model number on the switch box is MS1-090. Thanks for whatever help you can give.
You also need to say if the feed motor is dc or ac, and how it is wired now. Sounds like you might want to call in an electrician.
I am not sure where you are located, but a lot of the companies that sell electric motors carry all the switches and electrical needs for most woodworking equipment.