Loft Apartment Kitchen

Listing #719 Listed on: 06/06/2007 Company Name: Scribe Mark Woodworks
Name: John Cotten

All Maple kitchen. The edging on the doors and drawers are 1/8" solid maple. The owners did not want edgebanding used.

(No images available for this project.)
0 Photos
Social Media:
Viewer Comments:
Posted By:steve
Did you edge the doors before laying the veneer or is bought veneered board? I had the pleasure of a job in London where we did the edges with about 10mm stock applies with heat and urea glue before veneering both sides in a big heated press. Raw mdf to finished door in less than an hour if you just made one.
Posted By:John Cotten
We used maple veneered MDF, then glued and pinned the strips with a 23 guage pinner. Then routed the edges to trim flush. We could do a door in about 5 to 10 minutes depending on the size of the door with the parts cut first. Although, prepping the thin stock as a bit of a pain. We ripped first, then planed with a 12" Makita planer. I have a 20" planer, but it was somewhat over kill. The Makita did a nicer finish job on the thin stock.

Add Your Comment:

*Enter the correct numbers into the field below:

Date of your Birth:

WalzCraft Original Saw