They look like quality items, Harvey - nice job.
How accurate are they, and how long did it take to make them? If someone asked you to make one for them, what would it cost?
Thanks Sam. I haven't checked the accuracy yet. The alignment pin holes were machined on a CNC mill, so they should be real close. I started these while my shop was slow, and then things got busy. It probably took me 5 months to get them finished, so I wasn't paying very close attention to the time that it took. I would guess we had about 10 hours each in them, and I could probably make them in about 1/2 of that now.
I really haven't had any time to try them yet, so I'm not sure if I would make them the same the next time.
Hi I am really trying to buy goods made in the US. If you have checked the accuracy and can make additional I would sure like the opportunity to purchase.
Dave, I'm not set up to produce these. I still haven't check the accuracy, but it's been more than good enough for the plastic fabrications that I use them for.