|
|
|
A Small Solar Kiln 
Question
 Click here for higher quality, full size image Forum Responses
From the original questioner: I have enough red and white oak cut for at least 2 and maybe 3 more charges (about 300 bf per charge?). I've recently cut some cherry and locust that I'll air dry a few months, so probably have all I can use for this summer. Guess I'll leave a charge in through the winter as well. It might not dry a lot, but it will be out of the elements...? Good news is I'll have more than I have time to use this winter when I do most of my woodworking - shop is heated, but not cooled. I also plan to move the fan solar panels more to the center for the next charge, as this should give them a bit longer run time as they are partially shaded by the sides.
From contributor J: Nice job on the kiln. I'd love to know your source for the solar fans. Let us know how the oak turns out when it's finished drying. From the original questioner: The fans I used are from Home Depot. They are attic gable fans. I think they were about a 12" fan. From contributor Y: Nice job. It appears from the image that that the photovoltaics (PVs) are mounted inside the kiln. If that is true, then you will experience significantly decreased output. They like to be cool. You will get a much better output if you can mount them outside. Another source of DC fans is radiator fans from salvage yards. From the original questioner: Thanks for the information. I was going to move the panels anyway, so went ahead this morning and moved them outside the kiln. Cloudy here today, so may not see much difference, but thanks again for the feedback. From Professor Gene Wengert, forum technical advisor: Looks great. If you use some of the incoming solar energy to make electricity, then it will not be available for heat, and your kiln will be slower and less effective. So having the electric panels outside and separate from the roof collector is desirable. From the original questioner: Wanted to pass along an update. About two weeks ago, did some measurements and had an average of 8.9% MC for 10 readings. Yesterday, checked again and at 7.5% for 10 readings so all in all, looks like it's working well. Will probably pull this load out next weekend if the MC doesn't appear to be getting any lower. Have another load ready to go, so no downtime for a while! Would you like to add information to this article? Interested in writing or submitting an article? Have a question about this article? Have you reviewed the related Knowledge Base areas below? 
|
