African Mahogany and Reaction Wood

      African Mahogany seems to be prone to stress, causing the material to twist and warp when sawn. March 13, 2007

I received a 500bf bundle of random width African mahogany and when I cut it, it went crazy. Seems to have a lot of stress in it. Since this wood seems to have a very wild grain, is it natural for it to be unstable when cut, or did I just get a bad batch from the kiln?

Forum Responses
(Sawing and Drying Forum)
From contributor K:
I am not sure if this is the case with yours, but I have seen a lot more reaction wood in the African mahogany than in the genuine. I am not sure why, if they are grown under more harsh conditions, like leaning or near a clearing, with unbalanced canopy, or just what the cause may be.

I would just suggest that you or whomever starts the initial milling process should learn to recognize it in the rough, and set those boards out and return them to the supplier. I got a flier in the mail a couple of years ago that had an article by some college professor that had some tips for how to go about sharpening and milling reaction wood for better yield. Which induced a wild kind of laugh from me.

Yield from saving a few board feet could never equal or offset the headaches that follow using a wood that is unstable, brash, and won't finish like all of the rest of the wood around it, not to mention that it is weaker.

From contributor T:
I have used a lot of African mahogany and found bad/wild and twist in some of it too. I ended up putting it aside and using for short stock. Don't use that crazy lumber in your projects. It will cause headaches later even if you rip and glue it. It may look okay when it's in the shop, but out on the job you will most likely get a call sooner or later to replace same. Been there!

Would you like to add information to this article?
Interested in writing or submitting an article?
Have a question about this article?

Have you reviewed the related Knowledge Base areas below?
  • KnowledgeBase: Knowledge Base

  • KnowledgeBase: Primary Processing

  • KnowledgeBase: Primary Processing: Sawmilling

    Would you like to add information to this article? ... Click Here

    If you have a question regarding a Knowledge Base article, your best chance at uncovering an answer is to search the entire Knowledge Base for related articles or to post your question at the appropriate WOODWEB Forum. Before posting your message, be sure to
    review our Forum Guidelines.

    Questions entered in the Knowledge Base Article comment form will not generate responses! A list of WOODWEB Forums can be found at WOODWEB's Site Map.

    When you post your question at the Forum, be sure to include references to the Knowledge Base article that inspired your question. The more information you provide with your question, the better your chances are of receiving responses.

    Return to beginning of article.

    Refer a Friend || Read This Important Information || Site Map || Privacy Policy || Site User Agreement

    Letters, questions or comments? E-Mail us and let us know what you think. Be sure to review our Frequently Asked Questions page.

    Contact us to discuss advertising or to report problems with this site.

    To report a problem, send an e-mail to our Webmaster

    Copyright © 1996-2019 - WOODWEB ® Inc.
    All rights reserved. No part of this publication may be reproduced in any manner without permission of the Editor.
    Review WOODWEB's Copyright Policy.

    The editors, writers, and staff at WOODWEB try to promote safe practices. What is safe for one woodworker under certain conditions may not be safe for others in different circumstances. Readers should undertake the use of materials and methods discussed at WOODWEB after considerate evaluation, and at their own risk.

    WOODWEB, Inc.
    335 Bedell Road
    Montrose, PA 18801

    Contact WOODWEB

  • WOODWEB - the leading resource for professional woodworkers

      Home » Knowledge Base » Knowledge Base Article