Boxing Out Columns
Quick tips on wrapping columns with a four-sided hardwood box. November 28, 2011
I have to clad 20 steel posts, 100mm diameter, in merbu. I wanted to use mitre joins for the look of a solid piece of timber. The timbers are going to end up 3000x150x19 and are going to be difficult to join up. Can anyone suggest a good method? I was planning to use biscuits to hold the mitre in place while the glue sets but am open to ideas
(Cabinet and Millwork Installation Forum)
From contributor J:
Most of us have never worked with merbu, but assuming it isn't a difficult wood to glue, here is what I'd do.
Mill all your parts
Widebelt sand them
Miter the parts
Cut the parts to length
Lay 4 together, flush up the ends
Get some clear packing tape, and tape them together
Flip them over and apply glue
Fold up three parts and get it around the post and tape the final corner
Shoot a few pins if you want and go on to the next
Peel off the tape, give it a quick sand and break the edges
From contributor L:
We would do it with lock miters, easy to glue-up. If you have space between the column and the panels I'd put 3 of the parts together in the shop around an MDF U frame pocket screwed from inside. On site slide them around the columns and glue and clamp the 4th side in place. You may need to use a few blocks inside the enclosure to locate and make solid the whole affair.
Would you like to add information to this article?
Interested in writing or submitting an article?
Have a question about this article?
Have you reviewed the related Knowledge Base areas below?
KnowledgeBase: Knowledge Base
KnowledgeBase: Architectural Millwork: Custom Millwork
KnowledgeBase: Architectural Millwork: Millwork Installer
All rights reserved. No part of this publication may be reproduced in
any manner without permission of the Editor.
Review WOODWEB's Copyright Policy.
The editors, writers, and staff at WOODWEB try to promote safe practices.
What is safe for one woodworker under certain conditions may not be safe
for others in different circumstances. Readers should undertake the use
of materials and methods discussed at WOODWEB after considerate evaluation,
and at their own risk.
335 Bedell Road
Montrose, PA 18801
Copyright © 1996-2019 - WOODWEB ® Inc.