Dedicated vs. power-fed tablesaw ripping
Increasing productivity by upgrading to a straight-line, dedicated saw. August 29, 2001
Q.
We process 10,000-15,000 board feet of various hardwoods per year and are looking for ways to increase productivity. Presently, we straightline rip on a sliding table saw and then take the boards to a heavy duty table saw with a power feeder for ripping to width. This saw could use more horsepower (it's 5hp). If we are going to upgrade, is it worth the expense of moving up to a straight line dedicated saw?
Forum Responses
Just by the simple fact that you would be down to working on one tool, a straight line would be worth the cost. As an example, we have for sale a 15 hp dip chain straight line right now for $3500. There are others in this class also available, and compare that to buying a new 7.5 hp table saw. Tough to find a table saw with more power than that. Do the math and I think you'll see the answer. Once you get the feel of a straight line, you will be amazed at both the yield and time efficiency of the tool.
From contributor B:
Yes. I had a saw with a feeder and it worked very well. When I found a used import straight line rip I upgraded. It has 7hp and rips 1" very well, however it is not enough HP to do too much 2". Not needing a straight edge to cut and not having the feeder slip makes it a real joy to use. I cross-cut most of my stock first, so with one operator you can stay busy stuffing it in one end and picking it up on the other. I am using a glue joint rip blade from Systi-Matic. It does a fantastic job.
From contributor T:
I would be interested in knowing what your end product(s) is and how you receive your raw lumber (straightlined and surfaced already, perhaps?).
From contributor B:
I make kitchen and bath cabinets using the 32mm system of construction. My material comes H&M 15/16. Most lumber is cut for door and drawer fronts as well as other trim parts.
From contributor T:
Thinking of an old tilt table, belt driven Yates American or similar brand set up with a feeder and dedicated to certain ripping jobs.
The arbor is longish and can sometimes run two blades with a spacer in between (cleat stock, etc.). The cost of such a saw can be $1200 or less. Often it has 10 hp.
For short pieces, a hopper may be advised. A hundred fpm is not uncommon on these beasts. Blade projection can easily be 6". You have a straight edge already so fence feeding will retain it.
Would you like to add information to this article?
Interested in writing or submitting an article?
Have a question about this article?
Have you reviewed the related Knowledge Base areas below?
KnowledgeBase: Architectural Millwork
KnowledgeBase: Architectural Millwork: General
KnowledgeBase: Architectural Millwork: Moldings
KnowledgeBase: Solid Wood Machining
KnowledgeBase: Solid Wood Machining: General
KnowledgeBase: Solid Wood Machining: Setup and Maintenance
KnowledgeBase: Woodworking Miscellaneous
KnowledgeBase: Knowledge Base
Would you like to add information to this article? ...
Click Here
If you have a question regarding a Knowledge Base article, your best chance at uncovering an answer is to search the entire Knowledge Base for related articles or to post your question at the appropriate WOODWEB Forum. Before posting your message, be sure to review our Forum Guidelines.
Questions entered in the Knowledge Base Article comment form will not generate responses! A list of WOODWEB Forums can be found at WOODWEB's Site Map.
When you post your question at the Forum, be sure to include references to the Knowledge Base article that inspired your question. The more information you provide with your question, the better your chances are of receiving responses.
Return to beginning of article.
|
