Edging Boards at the Sawmill

      Lightly edge your own lumber on the mill, then re-edge after drying you'll produce more wood that way. January 27, 2007

I have a small one man M14 Foley Bellsaw sawmill which I have been working to bring online. What could I use to size my boards, 4, 6, or 8 inches wide, once they are cut? My goal is about 2000 board feet a week of white or red oak.

Forum Responses
(Sawing and Drying Forum)
From Professor Gene Wengert, forum technical advisor:
Hardwoods, like red oak, are sold random width in most cases, which will give you more footage than sawing to a specific size. To help in proper edging, Joe Denig and I wrote a book about sawing and edging called "Sawing, Edging and Trimming Hardwood Lumber: Putting Theory Into Practice."

From contributor A:
If you are planning on drying the wood yourself, I would edge lightly and then trim them down after drying. You will gain more lumber even though you waste some drying space in the kiln.

On an old Bellsaw, we used to take an opening cut, then rotate 90 degrees so we were cutting flitches with at least one trimmed side. We would then put them back on the carriage with the flattened side to the back and an oak 4x4 on top to run them back through to edge. The edger man can kill a mill's profits.

Would you like to add information to this article?
Interested in writing or submitting an article?
Have a question about this article?

Have you reviewed the related Knowledge Base areas below?
  • KnowledgeBase: Knowledge Base

  • KnowledgeBase: Primary Processing

  • KnowledgeBase: Primary Processing: Sawmilling

    Would you like to add information to this article? ... Click Here

    If you have a question regarding a Knowledge Base article, your best chance at uncovering an answer is to search the entire Knowledge Base for related articles or to post your question at the appropriate WOODWEB Forum. Before posting your message, be sure to
    review our Forum Guidelines.

    Questions entered in the Knowledge Base Article comment form will not generate responses! A list of WOODWEB Forums can be found at WOODWEB's Site Map.

    When you post your question at the Forum, be sure to include references to the Knowledge Base article that inspired your question. The more information you provide with your question, the better your chances are of receiving responses.

    Return to beginning of article.

    Refer a Friend || Read This Important Information || Site Map || Privacy Policy || Site User Agreement

    Letters, questions or comments? E-Mail us and let us know what you think. Be sure to review our Frequently Asked Questions page.

    Contact us to discuss advertising or to report problems with this site.

    To report a problem, send an e-mail to our Webmaster

    Copyright © 1996-2019 - WOODWEB ® Inc.
    All rights reserved. No part of this publication may be reproduced in any manner without permission of the Editor.
    Review WOODWEB's Copyright Policy.

    The editors, writers, and staff at WOODWEB try to promote safe practices. What is safe for one woodworker under certain conditions may not be safe for others in different circumstances. Readers should undertake the use of materials and methods discussed at WOODWEB after considerate evaluation, and at their own risk.

    WOODWEB, Inc.
    335 Bedell Road
    Montrose, PA 18801

    Contact WOODWEB

  • WOODWEB - the leading resource for professional woodworkers

      Home » Knowledge Base » Knowledge Base Article