Hanging Crown Moulding on Wavy Walls
Tips for blending crown into an irregular wall surface. April 6, 2007
Few things look worse than crown molding hung so that it follows a wavy wall. Here in Las Vegas, a tract home selling for $750,000 will typically have walls that are serpentine 1/2" off a straight line in a 30 foot span. My procedure has been to first stretch a string along the wall from corner to corner at the crown drop and to tack shims to the wall where needed. This sometimes leaves gaps too wide for typical caulking to fill. If the customer is unwilling to have the walls floated out, what are some alternatives to this problem?
(Architectural Woodworking Forum)
From contributor A:
We ran into this situation. We first put up a strip of thin dentil molding, although you could use whatever. This was nailed tight to follow the curve. The worst bow was about 3/8", so the top of the dentil was 1/2". Well, actually, it was 3/4", but there was a 1/2" X 1/2" rabbet on the top. This gave somewhere to nail without exposing the nails. When the crown was set on top, we were able to run the crown straight because the 1/2" deep rabbet compensated for the bows. Looked great when it was done. There were no gaps along the wall and the crown was straight. Hope this at least gives some ideas.
From Gary Katz, forum technical advisor:
I've never had to shim the wall first. But I do snap a line, frequently. That's what keeps you honest when the wall or ceiling isn't straight. You can usually cheat off the line about 1/4” in either direction. Any more is noticeable. Sometimes less on a low ceiling. Once the crown is tacked to the wall, we shim bows or bellies. Then have the drywallers or painters float them out if they’re bad. Installing something - even baseboard upside down - beneath the crown helps a lot, too.
From contributor J:
We first hang a 3" rail of hardwood or edgebanded ply for the bottom of the crown to land on. Keep it perfectly straight by shimming where necessary. Hide the shims or gaps with a piece of nose and cove that rides the wall. Install the crown on the rail, leaving a small reveal. It is an extra step, but also a nice detail and it will eliminate coping.
Would you like to add information to this article?
Interested in writing or submitting an article?
Have a question about this article?
Have you reviewed the related Knowledge Base areas below?
KnowledgeBase: Knowledge Base
KnowledgeBase: Architectural Millwork
KnowledgeBase: Architectural Millwork: Millwork Installer
All rights reserved. No part of this publication may be reproduced in
any manner without permission of the Editor.
Review WOODWEB's Copyright Policy.
The editors, writers, and staff at WOODWEB try to promote safe practices.
What is safe for one woodworker under certain conditions may not be safe
for others in different circumstances. Readers should undertake the use
of materials and methods discussed at WOODWEB after considerate evaluation,
and at their own risk.
335 Bedell Road
Montrose, PA 18801
Copyright © 1996-2018 - WOODWEB ® Inc.