In search of flat doors
Even slightly inaccurate machining can produce frame-and-panel doors which are less than flat. June 6, 2001
I am making paneled doors with M&T construction. When dry assembled, I notice that some are not flat (I test by balancing them on their edges and sighting down them). The stock is flat and the joints are accurately cut, but obviously, something is wrong. How do you achieve perfect flatness?
Do you use "set-up blocks" when setting up your knives? There could be inconsistent cutting by a fraction, which mis-aligns the joint. For example: the tenon on one end of the rail could be very slightly different from that on the other end, if you had different set-up times. I like to do all the stiles with the same set-up, then using one of them as a set-up block, align the knives in the spindle and make sure it turns freely without scraping. Accurate set-up should take the wind out.
My experience is that winding doors are usually caused by a twist in the panels. Place your panels on an absolutely flat surface such as a cast iron table saw top and see if they rock a bit. If so, that is your problem.
Perfect flatness is an unachievable goal. But we can dream and try. If your machined joints slip together flatly and finely, then the only trouble can be in your clamping bed. Lay a straightedge across corner to corner, side to side, and edge to edge, until you are fully confident all clamping points are co-planar.
Would you like to add information to this article?
Interested in writing or submitting an article?
Have a question about this article?
Have you reviewed the related Knowledge Base areas below?
KnowledgeBase: Cabinetmaking: Cabinet Door Construction
KnowledgeBase: Solid Wood Machining
KnowledgeBase: Solid Wood Machining: General
KnowledgeBase: Knowledge Base
All rights reserved. No part of this publication may be reproduced in
any manner without permission of the Editor.
Review WOODWEB's Copyright Policy.
The editors, writers, and staff at WOODWEB try to promote safe practices.
What is safe for one woodworker under certain conditions may not be safe
for others in different circumstances. Readers should undertake the use
of materials and methods discussed at WOODWEB after considerate evaluation,
and at their own risk.
335 Bedell Road
Montrose, PA 18801
Copyright © 1996-2019 - WOODWEB ® Inc.