Kitchen Layout Problem: Range in the Corner
Advice about how a kitchen stove can be located in the room corner, with the front facing into the room. December 27, 2010
I am designing a kitchen with a corner stove detail. The wall is 90 degrees, so some type of sheet rock build out will have to be installed to create the 45 degree corner. I'm having a hard time visualizing how this stove will fit in with the cabs that run into it, as well as the upper cabs. Here's the look I'm going for:
Click here for higher quality, full size image
From contributor T:
If your design software doesn't allow you to get at least an idea of how the layout will look, draw it on the shop floor.
From contributor E:
I just completed a 45 degree corner stove kitchen. I did not build out the corner, just left it at 90 with extra countertop behind the stove. The cabinets on either side go back at 45 degrees. I build frameless, but I added a 1 3/4 inch face frame at the end of each cabinet to prevent a conflict with the oven door and cabinet fronts with the fronts overlaying 1/4 inch. I set the depth of the stove further back than the normal depth in a straight run, which seems to help. Also, the upper housed a vent microwave with a cabinet above with extra deep storage. A full size drawing on a sheet of 1/4 inch ply helped with the layout.
From contributor J:
Give yourself enough room for drawers and doors next to the stove. I did on the last one and it was still a little close. I had to draw out the upper on a sheet of 1/4" since it had a microwave hood, as my software couldn't quite do it.
Would you like to add information to this article?
Interested in writing or submitting an article?
Have a question about this article?
Have you reviewed the related Knowledge Base areas below?
KnowledgeBase: Knowledge Base
KnowledgeBase: Cabinetmaking: Cabinet Design
All rights reserved. No part of this publication may be reproduced in
any manner without permission of the Editor.
Review WOODWEB's Copyright Policy.
The editors, writers, and staff at WOODWEB try to promote safe practices.
What is safe for one woodworker under certain conditions may not be safe
for others in different circumstances. Readers should undertake the use
of materials and methods discussed at WOODWEB after considerate evaluation,
and at their own risk.
335 Bedell Road
Montrose, PA 18801
Copyright © 1996-2017 - WOODWEB ® Inc.