Sawing a Cedar Log for Benches

      You can wait to saw the log as long as you keep it dry. July 30, 2007

During a recent storm, a very large cedar tree was uprooted and fell. I would like to take the trunk of this tree and make two benches. The trunk is large enough to cut into lumber for two benches. How do I properly dry the trunk so that it does not split or warp?

Forum Responses
(Sawing and Drying Forum)
From contributor K:
Just to the right of your message is a link in blue that says "find a sawyer." If you click on that, you will find a column listed by state. After you get it cut, go to the home page and type "how to dry wood" into the little search window. You will find more than you ever wanted to know. Fortunately cedar is pretty easy to dry, especially for a bench, but I am assuming it will be outside.

From contributor J:
You'll want to have it cut sooner rather than later. I'm not sure of the specifics of cedar, but the nature of wood's cellular structure generally causes logs to degrade badly if dried when whole.

From contributor C:
If it is ERC, you can cut it any time you like. It will be good several years from now if you keep the log off the ground. When sawn, keep the wood out of the sun. On stickers in a shed is the best place. Do not put it in a heated room. If sawn now, the wood will be dry enough by mid-summer for outdoor benches. ERC shrinks the least of any of our Midwest species when it changes moisture content.

From contributor D:
Try to get it cut sooner rather than later, as I have found that some of these aromatic softwoods can develop radial cracks if left in log form that may render the wood useless as slabs.

From contributor A:
Having it sawn on a band mill will make it easier to sand smooth later. Eastern red cedar will wait for years to be sawn if kept off the ground.

Would you like to add information to this article?
Interested in writing or submitting an article?
Have a question about this article?

Have you reviewed the related Knowledge Base areas below?
  • KnowledgeBase: Knowledge Base

  • KnowledgeBase: Primary Processing

  • KnowledgeBase: Primary Processing: Sawmilling

    Would you like to add information to this article? ... Click Here

    If you have a question regarding a Knowledge Base article, your best chance at uncovering an answer is to search the entire Knowledge Base for related articles or to post your question at the appropriate WOODWEB Forum. Before posting your message, be sure to
    review our Forum Guidelines.

    Questions entered in the Knowledge Base Article comment form will not generate responses! A list of WOODWEB Forums can be found at WOODWEB's Site Map.

    When you post your question at the Forum, be sure to include references to the Knowledge Base article that inspired your question. The more information you provide with your question, the better your chances are of receiving responses.

    Return to beginning of article.

    Refer a Friend || Read This Important Information || Site Map || Privacy Policy || Site User Agreement

    Letters, questions or comments? E-Mail us and let us know what you think. Be sure to review our Frequently Asked Questions page.

    Contact us to discuss advertising or to report problems with this site.

    To report a problem, send an e-mail to our Webmaster

    Copyright © 1996-2020 - WOODWEB ® Inc.
    All rights reserved. No part of this publication may be reproduced in any manner without permission of the Editor.
    Review WOODWEB's Copyright Policy.

    The editors, writers, and staff at WOODWEB try to promote safe practices. What is safe for one woodworker under certain conditions may not be safe for others in different circumstances. Readers should undertake the use of materials and methods discussed at WOODWEB after considerate evaluation, and at their own risk.

    WOODWEB, Inc.
    335 Bedell Road
    Montrose, PA 18801

    Contact WOODWEB

  • WOODWEB - the leading resource for professional woodworkers

      Home » Knowledge Base » Knowledge Base Article