Sources for Mold-Making Materials and Info
Here's a list of vendors who supply materials you can use to create a mold of an existing moulding, in order to reproduce the piece using cast plaster. September 15, 2011
On many occasions I have read about making flexible molds for duplicating intricate parts in plaster. The products for making these molds are typically poured around the part and then cured. The original part is removed and you have a mold for making duplicates out of materials such as plaster. Can anyone give me a lead on where to purchase this mold making material?
(Architectural Woodworking Forum)
From contributor G:
Here's one way - over-catalyzed bondo.
Polyester and Epoxy Wood Repair
Would you like to add information to this article?
Interested in writing or submitting an article?
Have a question about this article?
Have you reviewed the related Knowledge Base areas below?
KnowledgeBase: Knowledge Base
KnowledgeBase: Architectural Millwork
KnowledgeBase: Architectural Millwork: Millwork Restoration
All rights reserved. No part of this publication may be reproduced in
any manner without permission of the Editor.
Review WOODWEB's Copyright Policy.
The editors, writers, and staff at WOODWEB try to promote safe practices.
What is safe for one woodworker under certain conditions may not be safe
for others in different circumstances. Readers should undertake the use
of materials and methods discussed at WOODWEB after considerate evaluation,
and at their own risk.
335 Bedell Road
Montrose, PA 18801
Copyright © 1996-2018 - WOODWEB ® Inc.