Instructions: Hardwood Lumber Board Footage CalculatorThickness:
Enter the nominal thickness of the lumber. Nominal thickness of hardwood lumber is traditionally the minimum thickness when green or air-dried. For pieces under 1-inch thick (such as 3/4) use a nominal thickness of 1-inch.
Enter lumber length reducing if necessary to the nearest foot. Any inches entered (in length) will not be considered during the calculation. This is accepted practice when calculating hardwood lumber board footage.
Enter the actual width -including fractions of inches.
No. of pieces this size:
Enter whole number values (no decimals or fractions)
A detailed discussion of Board Footage
What is a Board Foot, by Gene Wengert
can be viewed at WOODWEB's Knowledge Base by clicking on the link above. WOODWEB strongly recommends reading this article if you are unfamiliar with the process of calculating hardwood lumber board footage.
Click Here to Access the Hardwood Lumber Board Footage Calculator
All rights reserved. No part of this publication may be reproduced in any manner without permission of the Editor.
Review WOODWEB's Copyright Policy.
The editors, writers, and staff at WOODWEB try to promote safe practices. What is safe for one woodworker under certain conditions may not be safe for others in different circumstances. Readers should undertake the use of materials and methods discussed at WOODWEB after considerate evaluation, and at their own risk.
335 Bedell Road
Montrose, PA 18801
Contact WOODWEB Copyright © 1996-2015 - WOODWEB ® Inc.