Crown Moulding for a Vaulted Ceiling

      Tips for applying crown molding into a 30-degree ceiling joint. June 16, 2005

Any suggestions for moulding that surrounds a room with a 30 degree vaulted ceiling? I have done flat moulding for this customer in other rooms, but she wants something more decorative.

Forum Responses
(Cabinet and Millwork Installation Forum)
Top it with a shelf to make the crown into a ledge. You'll need to put up the shelf top first, then install the molding below. A narrow strip on the wall gives a nailer for the shelf top and can be used to keep the whole shebang level. You may have to bevel the lower edge of the nailer to clear the back of the crown molding, depending on the width of the molding.

A good size crown with up lighting into the vault can make a nice look. Make sure there is no view from a second landing. The shelf idea is nice, too. There are some really nice carved wide casings that could make a nice division. Have you seen or used any of the super-sized foam moldings? It does depend on what the interior looks like.

You can run crown molding around the room if you cut a new foot or shoulder on the top of the molding to match the slope of the ceiling. I use a 45 degree fixture that clamps to the fence on my table saw.

Would you like to add information to this article?
Interested in writing or submitting an article?
Have a question about this article?

Have you reviewed the related Knowledge Base areas below?
  • KnowledgeBase: Knowledge Base

  • KnowledgeBase: Architectural Millwork

  • KnowledgeBase: Architectural Millwork: Millwork Installer

  • KnowledgeBase: Architectural Millwork: Moldings

    Would you like to add information to this article? ... Click Here

    If you have a question regarding a Knowledge Base article, your best chance at uncovering an answer is to search the entire Knowledge Base for related articles or to post your question at the appropriate WOODWEB Forum. Before posting your message, be sure to
    review our Forum Guidelines.

    Questions entered in the Knowledge Base Article comment form will not generate responses! A list of WOODWEB Forums can be found at WOODWEB's Site Map.

    When you post your question at the Forum, be sure to include references to the Knowledge Base article that inspired your question. The more information you provide with your question, the better your chances are of receiving responses.

    Return to beginning of article.

    Refer a Friend || Read This Important Information || Site Map || Privacy Policy || Site User Agreement

    Letters, questions or comments? E-Mail us and let us know what you think. Be sure to review our Frequently Asked Questions page.

    Contact us to discuss advertising or to report problems with this site.

    To report a problem, send an e-mail to our Webmaster

    Copyright © 1996-2016 - WOODWEB ® Inc.
    All rights reserved. No part of this publication may be reproduced in any manner without permission of the Editor.
    Review WOODWEB's Copyright Policy.

    The editors, writers, and staff at WOODWEB try to promote safe practices. What is safe for one woodworker under certain conditions may not be safe for others in different circumstances. Readers should undertake the use of materials and methods discussed at WOODWEB after considerate evaluation, and at their own risk.

    WOODWEB, Inc.
    335 Bedell Road
    Montrose, PA 18801

    Contact WOODWEB

  • WOODWEB - the leading resource for professional woodworkers

      Home » Knowledge Base » Knowledge Base Article