Design of air drying sheds
General info on the design of sheds used for air-drying lumber. 1998.
by Professor Gene Wengert
Q.
We are thinking of building air drying sheds to decrease air drying degrade. Is there design info available? If so where can I get it?
A.
I haven’t seen a standard design. Gary Ort’s mill has the typical design. We need adequate spacing between packs (24 inches edge to edge) and at least a 3 ft overhang, plus gutters.
Professor Gene Wengert is Extension Specialist in Wood Processing at the Department of Forestry, University of Wisconsin-Madison.
Click on Wood Doctor Archives to peruse past answers.
If you would like to obtain a copy of "The Wood Doctor's Rx", visit the Wood Education and Resource Center Web site for more information.
Would you like to add information to this article?
Interested in writing or submitting an article?
Have a question about this article?
Have you reviewed the related Knowledge Base areas below?
KnowledgeBase: Lumber & Plywood: Storage
KnowledgeBase: Primary Processing: Air Drying Lumber
KnowledgeBase: Knowledge Base
Would you like to add information to this article? ...
Click Here
If you have a question regarding a Knowledge Base article, your best chance at uncovering an answer is to search the entire Knowledge Base for related articles or to post your question at the appropriate WOODWEB Forum. Before posting your message, be sure to review our Forum Guidelines.
Questions entered in the Knowledge Base Article comment form will not generate responses! A list of WOODWEB Forums can be found at WOODWEB's Site Map.
When you post your question at the Forum, be sure to include references to the Knowledge Base article that inspired your question. The more information you provide with your question, the better your chances are of receiving responses.
Return to beginning of article.
|
