Gluing PVC Foamboard to Wood
Suggestions for adhering closed-cell PVC panel goods to a wood substrate. November 30, 2009
Does anyone know of a quick-set glue to bond plastic (sintra) to wood?
From contributor D:
Back when I was in film set construction we'd use sintra as easy white stage floors. We'd rough up the back (say 80 grit) and stick it down to the substrate with solvent-based contact cement. It stuck forever!
From contributor J:
Locktite power grab works well. It is not "instant" as advertised, but if you apply and cure 24 hours above 57 degrees it will work.
Would you like to add information to this article?
Interested in writing or submitting an article?
Have a question about this article?
Have you reviewed the related Knowledge Base areas below?
KnowledgeBase: Knowledge Base
KnowledgeBase: Adhesives, Gluing and Laminating
All rights reserved. No part of this publication may be reproduced in
any manner without permission of the Editor.
Review WOODWEB's Copyright Policy.
The editors, writers, and staff at WOODWEB try to promote safe practices.
What is safe for one woodworker under certain conditions may not be safe
for others in different circumstances. Readers should undertake the use
of materials and methods discussed at WOODWEB after considerate evaluation,
and at their own risk.
335 Bedell Road
Montrose, PA 18801
Copyright © 1996-2018 - WOODWEB ® Inc.