Sanding Through Layers to Match a Finish
By carefully sanding through one layer at a time, you can learn something about how the finish was applied. March 8, 2007
From contributor M:
This sample shows you how sanding off each layer of a finish will tell you how it was finished. When you make up your own samples, you then follow the way it was built up. It gives you a way of learning how to finish and learn about colors and materials, and it gives you the chance to make changes if they are needed in the sample.
Click here for higher quality, full size image
Would you like to add information to this article?
Interested in writing or submitting an article?
Have a question about this article?
Have you reviewed the related Knowledge Base areas below?
KnowledgeBase: Knowledge Base
KnowledgeBase: Finishing: Refinishing
All rights reserved. No part of this publication may be reproduced in
any manner without permission of the Editor.
Review WOODWEB's Copyright Policy.
The editors, writers, and staff at WOODWEB try to promote safe practices.
What is safe for one woodworker under certain conditions may not be safe
for others in different circumstances. Readers should undertake the use
of materials and methods discussed at WOODWEB after considerate evaluation,
and at their own risk.
335 Bedell Road
Montrose, PA 18801
Copyright © 1996-2019 - WOODWEB ® Inc.