Spots revealed in dry, planed lumber
Dr. Gene attempts to find the causes of discolored spots on dried lumber, revealed only when the stock has been planed. 1998.
Professor Gene Wengert
Q.
Have you ever heard of a spray in the later part of a schedule causing funny discoloration on hard maple? These spots look like oil spots and can not be seen until surfacing. They are very few and we haven't established a pattern as of this time but feel strongly it is from our drying process. When the sprays come on the reservoir fills and doesn't drain fast enough to keep water from coming out the header and wetting the wood.
Could this be causing the spots? We have new American package kilns pushing air through 14" of wood. We treat our water with Nalco chemicals and our water source was recently treated with chlorine.
A.
The spots could be from several sources---they could be because of water on the surface (rain or snow) that doesn't let the interior dry fast enough, and so the wood develops interior chemical stain.
They could be spots where a lumber fungicide resulted in penetration by certain discoloration chemicals due to the surfactant in the solution. Or it could be the pH of the dip solution is a factor.
They could be spots where the boiler water (not steam) dripped on the lumber.
In most cases, the quick drying of the surface leaves the surface color in good shape, but subsequent surface treatments/events discolor the interior.
We do not see these spots with fresh logs and quick drying. Look for a problem at MCs over 40% MC.
Why are you steaming at intermediate stages of drying--steam should not be required until equalizing and conditioning?
Professor Gene Wengert is Extension Specialist in Wood Processing at the Department of Forestry, University of Wisconsin-Madison.
Click on Wood Doctor Archives to peruse past answers.
If you would like to obtain a copy of "The Wood Doctor's Rx", visit the Wood Education and Resource Center Web site for more information.
Would you like to add information to this article?
Interested in writing or submitting an article?
Have a question about this article?
Have you reviewed the related Knowledge Base areas below?
KnowledgeBase: Primary Processing: Kiln Operation
KnowledgeBase: Wood Engineering: Wood Properties
KnowledgeBase: Woodworking Miscellaneous: Woodworking
KnowledgeBase: Knowledge Base
Would you like to add information to this article? ...
Click Here
If you have a question regarding a Knowledge Base article, your best chance at uncovering an answer is to search the entire Knowledge Base for related articles or to post your question at the appropriate WOODWEB Forum. Before posting your message, be sure to review our Forum Guidelines.
Questions entered in the Knowledge Base Article comment form will not generate responses! A list of WOODWEB Forums can be found at WOODWEB's Site Map.
When you post your question at the Forum, be sure to include references to the Knowledge Base article that inspired your question. The more information you provide with your question, the better your chances are of receiving responses.
Return to beginning of article.
| 
