|Home » Forums » CNC » Message||Login|
You are not logged in. Consider these WOODWEB Member advantages:
Need a little help understanding this code2/7
Just trying to figure out this bit of g code for my Biesse Arrow
I get the UAO. The UIO is the offset for one of the drill bits in the drill bank (I think).
What's the purpose of the UTO after the UAO? It seems redundant.
What's ME47? It's not in the programming manual.
What is AXO and under what conditions is it used?
The UTO would be used if you wanted to position the work (panel) in a location on the table other than referencing the corner of the table (using pop up pins and pods for example)