|Home » Forums » CNC » Message||Login|
You are not logged in. Consider these WOODWEB Member advantages:
Vacuum Pump type4/17
We are having problems with our Becker vacuum pumps. The vanes are expensive and we had some fail after a few months. They are suggesting the 5 year old pump may need a rebuild. I have 2 so I am looking at alternatives.
I searched it and all the threads I come across are very old. are rotary vane the new standard or do people still spec liquid ring?
Any insight is appreciated.
I love my Sullair rotary screw.
Dump the vain pump. Get a used screw or liquid ring. Much more forgiving and heavy duty.
5 years for a rebuild seems extreme, how many hours a day are you running?
i recently saw a few shops with Atlas Copco variable speed pumps when on a tech tour with Biesse. The hold down was amazing, the pumps were very quiet. I think it might be more than new beckers but worth looking into imo.
On my previous machine I ran Becker vltf250. The first one was as old as the hills and pretty worn out and I would still get about 2 years out of it. I replaced it with a brand new Vltf250 and got the same life. My new machine has Bosch rotary claw pumps that are maintanence free for some ridiculous amount of hours and no consumble vanes and great vacuum. We clean the filter every couple weeks.
I have had a Travaini liquid ring vacuum pump that has had only regular maintenance over the past 15 years. We keep it in the compressor room, out of the dust, but I don't know if that is the reason for the long trouble free life. We put it in there to keep the heat and noise away from the operators. I have had less luck with rotary vane type pumps.
Mike how far is the plumbing from the compressor room to the machine?
I got a quote on a Dekker and a Kaeser. They are both over 20K. I could plumb the exhaust of the Dekker out so any oil it passes would not be an issue. My compressor room is quite far away from the Machine so I am not sure that is feasible. We have Kaeser compressors they are bulletproof but the maintenance cost is high.
If I was going to replace what I have I would lean towards the Dekker because I think the maintenance cost over time would be less.
I run 50 feet of 3" pipe from the pump to the CNC.
I used suction hose from a vacuum truck. Less expensive and has camlocks on both ends so easy to move and re-plumb.
Bill, not in the shop right now, but guessing 50-60 feet. Kaeser would be my choice.
I just reached out to them. I'll see what they say, thanks.
used to have 2 becker pumps and like you had many problems. After about 3 years of use we needed to rebuild. Eventually switched over to Travaini liquid ring pumps. We now have 4 and I would highly recommend. These run in pretty tough conditions and we have had little to no issues. The pumps vary in age from 1- 10 years in service.
After looking at many alternatives I bought a used Kaeser BSV100 with low hours.
We do not have it in production yet but I feel it will meet our needs.