|Home » Forums » Veneer Forum » Message||Login|
You are not logged in. Consider these WOODWEB Member advantages:
Some help with cherry veneer on concave hood5/8
Minimal experience applying veneers. Constructing a hood enclosure with three concave sides. I already have the skeleton assembled and ready for substrate and cherry veneer.
I don't have access to a bag and the last time I did a hip (not curved) hood I used titebond applied to both veneer and substare and let dry and then iron on. Ironing on a concave surface may prove problematic.
I have used Contact Adhesive on veneers similar to what you are describing. I have a picture of such a hood on my web site. That hood was done in 2006, I was in the home last year changing cabinets over a new refer and no problems.
I think one layer of bendable plywood would be enough. I would use a 20 mil backed veneer. I would do a really good job filling any voids with Bondo. You want that surface perfectly smooth. Any imperfections will telegraph through the veneer.
I would apply the side veneers first so my seams would be facing to the side.
Finally, I use only flammable Contact Adhesive and I apply it thoroughly.
Although you can get away with contact cement over time it is going to bite you eventually. If you are going to do curved work a vacuum press is the most flexible approach.
A vacuum bag lasts a long time as does a pump. Keep an eye on auctions for future work.
You might also consider subbing work like this out. You know your cost and you know you are going to make money in the end.
A range hood is a difficult environment for wood. I would want the most bulletproof approach. If it has an issue in a year or two it could cost more then a vacuum pump and bags cost to fix it.