Ipe Driveway Gate

Listing #4375 Listed on: 03/29/2014 Company Name: Distinctive Accents
Name: Gino Genna Member
Website:   Www.yourwoodworker.com

This is a 15' wide, 7' high double driveway gate constructed of ipe. I built in in three layers. The front and back layers are mortise and tennoned, gate-shaped frames. The middle layer has a 1"x3" steel frame layed into it. The joints in the middle layer are offset to the joints in the outer layers. I used West System epoxy as the adhesive. Every joint is mechanically reinforced with pegs, stainless bolts, or screws. This gate was installed 4 years ago and is holding up well. The joints look good. There are some surface checks.

1 Photos
Social Media:
Viewer Comments:
No Comments Yet

Add Your Comment:

*Enter the correct numbers into the field below:

Date of your Birth:

WalzCraft Original Saw