Keeping logs wet before milling

      Should logs be stored in water until they can be milled? June 27, 2000

Someone told me that I should keep my logs wet and that many mills have a "log pond" where they soak their logs to preserve them. It sounded to me like he didn't know what he was talking about. Is he full of it, or is he correct?

A lot of the larger mills around my area don't use ponds, but have water sprinklers going on the wood piles waiting until it is time to mill the logs. The smaller mills in my area usually use end sealer to cut down checking. I am sure a wood pond would work, if you had a large enough area for it.

It is quite a common practice around here, Mississippi, to keep long-term stored logs under sprinklers. Just about all the large commercial operations I know of, pine and hardwood, use sprinklers to preserve the winter stocks that build up during the summer.

Log ponds are a thing of the past -- several reasons include the accumulation of bark on the bottom, the sinking of logs immediately or after a while, the potential pollution of the water, and high bacterial activity in ponds without ample supplies of fresh water.

Use cold water for spraying the logs. Runoff can be a pollution problem, so check with your local water-quality people before you spend any money. The amount of water required is the equivalent of about 3 inches per day! There is a debate on using fine droplets (better coverage) or large droplets (less affected by wind). In any case, it is necessary to cover all the surfaces -- ends as well as faces. Using recycled water can weaken the protection -- the water becomes warm, invites bacterial activity, and contains progressively less oxygen.
Gene Wengert, forum moderator

Would you like to add information to this article?
Interested in writing or submitting an article?
Have a question about this article?

Have you reviewed the related Knowledge Base areas below?
  • KnowledgeBase: Primary Processing: Sawmilling

  • KnowledgeBase: Wood Engineering: Wood Properties

  • KnowledgeBase: Knowledge Base

    Would you like to add information to this article? ... Click Here

    If you have a question regarding a Knowledge Base article, your best chance at uncovering an answer is to search the entire Knowledge Base for related articles or to post your question at the appropriate WOODWEB Forum. Before posting your message, be sure to
    review our Forum Guidelines.

    Questions entered in the Knowledge Base Article comment form will not generate responses! A list of WOODWEB Forums can be found at WOODWEB's Site Map.

    When you post your question at the Forum, be sure to include references to the Knowledge Base article that inspired your question. The more information you provide with your question, the better your chances are of receiving responses.

    Return to beginning of article.

    Refer a Friend || Read This Important Information || Site Map || Privacy Policy || Site User Agreement

    Letters, questions or comments? E-Mail us and let us know what you think. Be sure to review our Frequently Asked Questions page.

    Contact us to discuss advertising or to report problems with this site.

    To report a problem, send an e-mail to our Webmaster

    Copyright © 1996-2021 -
    All rights reserved. No part of this publication may be reproduced in any manner without permission of the Editor.
    Review's Copyright Policy.

    The editors, writers, and staff at try to promote safe practices. What is safe for one woodworker under certain conditions may not be safe for others in different circumstances. Readers should undertake the use of materials and methods discussed at after considerate evaluation, and at their own risk.
    865 Troxel Road
    Lansdale, PA 19446

    Contact Us

  • WOODWEB - the leading resource for professional woodworkers

      Home » Knowledge Base » Knowledge Base Article